Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR
RM1880E _54 Brake _013226 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0068561 REAR SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE REAR WHEEL

Hide 4.REMOVE REAR SPEED SENSOR LH

C189959

a.

Disconnect the connector.


b.

Detach the connector.


c.

Detach the 3 clamps.


d.

Remove the bolt and speed sensor.

NOTICE:

Keep the sensor tip and sensor installation hole free from foreign matter.



Hide 5.REMOVE REAR SPEED SENSOR RH

a.

Detach the connector from the skid control sensor clamp.

C189958


b.

Disconnect the connector.


c.

Detach the 6 clamps.


d.

Remove the bolt and speed sensor.

NOTICE:

Keep the sensor tip and sensor installation hole free from foreign matter.



Hide 6.REMOVE SKID CONTROL SENSOR CLAMP

a.
C189957

Remove the bolt and skid control sensor clamp.