Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR
RM1880E _53 Suspension _013223 FRONT SUSPENSION _0068550 FRONT STABILIZER BAR A

FRONT SUSPENSION  FRONT STABILIZER BAR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT STABILIZER BAR

a.

Install the front stabilizer bar to the vehicle body.


Hide 2.INSTALL FRONT NO. 1 STABILIZER BAR BUSH

a.
C180046
0.667,1.531 1.292,1.531 1.292,1.531 1.469,1.333 true 0.458,1.417 0.792,1.677 0.333,0.26 10 false *1 2.74,0.156 3.063,0.458 0.323,0.302 10 false *a 2.969,1.76 3.26,2.042 0.292,0.281 10 false *b
*1 Bush Stopper
*a Outer Side
*b Vehicle Front


Install the 2 bushes.

HINT:
·

Install each bush to the outer side of the bush stopper on the stabilizer bar.


·

Install each bush with the slit of the bush facing the front of the vehicle.




Hide 3.INSTALL FRONT STABILIZER BRACKET

a.

Install the 2 brackets with the 4 bolts.

Torque:
48 N*m (489 kgf*cm, 35 ft.*lbf)

HINT:

Make sure the brackets' arrows face the front of the vehicle.



Hide 4.INSTALL FRONT STABILIZER LINK ASSEMBLY LH

a.

Install the 2 retainers, 2 cushions and stabilizer link.


b.

Install the front stabilizer link assembly LH with a new nut (upper side) and the nut (lower side).

Torque:
for upper side : 27 N*m (316 kgf*cm, 23 ft.*lbf)
for lower side : 78 N*m (795 kgf*cm, 58 ft.*lbf)

HINT:

If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.



Hide 5.INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.