Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM
RM1880E _54 Brake _013226 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0068558 ANTI-LOCK BRAKE SYSTEM J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  TC and CG Terminal Circuit  


DESCRIPTION

Connecting terminals TC and CG of the DLC3 causes the skid control ECU (brake actuator assembly) to display DTCs through ABS warning light blinking patterns.

WIRING DIAGRAM

C237134
5.49,1.781 6.031,2.063 0.542,0.281 10 false A13 5.479,1.958 7.063,2.583 1.583,0.625 10 false Skid Control ECU (Brake Actuator Assembly) 5.865,0.573 6.469,0.813 0.604,0.24 10 false TC 0.917,0.552 1.313,0.802 0.396,0.25 10 false TC 0.906,1.125 1.552,1.51 0.646,0.385 10 false CG 0.573,1.854 1.427,2.219 0.854,0.365 10 false G18 0.583,2.031 1.552,2.427 0.969,0.396 10 false DLC3 5.5,0.458 5.75,0.667 0.25,0.208 10 false 16 1.281,0.438 1.542,0.667 0.26,0.229 10 false 13 1.292,1.021 1.552,1.25 0.26,0.229 10 false 4

CAUTION / NOTICE / HINT

NOTICE:
·

Before disconnecting the connector, make sure that there are no problems with the connection.

·

After disconnecting the connector, make sure that the connector case and terminals are not deformed or corroded.



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (DLC3 - SKID CONTROL ECU)
a.

Turn the ignition switch off.


b.

Disconnect the skid control ECU (brake actuator assembly) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G18-4 (CG) - Body ground Always Below 1 Ω
G18-13 (TC) - A13-16 (TC) Always Below 1 Ω
A13-16 (TC) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS AND CONNECTOR