Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR
RM1880E _54 Brake _013226 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0068560 FRONT SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  FRONT SPEED SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

The procedures listed below is for the LH side.

·

Other than areas where instructions are provided, use the same procedure for the LH and RH sides.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with Work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE FRONT WHEEL

Hide 4.REMOVE FRONT SPEED SENSOR LH

a.

Disconnect the connector.

C188015
2.088,1.489 2.28,1.634 0.192,0.146 2.093,1.496 2.262,1.62 0.169,0.125 2.099,0.836 2.291,0.982 0.192,0.146 2.104,0.843 2.273,0.968 0.169,0.125 2.64,1.501 2.785,1.694 0.145,0.193 2.648,1.513 2.772,1.683 0.124,0.17 6.189,0.835 6.381,0.98 0.192,0.146 6.194,0.842 6.363,0.966 0.169,0.125 6.161,1.458 6.353,1.603 0.192,0.146 6.166,1.465 6.336,1.589 0.169,0.125 5.689,1.435 5.831,1.627 0.142,0.192 5.695,1.447 5.817,1.617 0.122,0.17 0.224,0.098 0.419,0.281 0.194,0.183 10 *A 3.989,0.099 4.163,0.28 0.175,0.181 10 *B
*A for LH *B for RH



b.

Detach the 2 clamps and connector.


c.
C281250

Detach the clamp and remove the bolt and harness clamp.


d.
C281251

Remove the bolt and harness clamp.


e.
C281252

Remove the 3 bolts, 2 harness clamps and speed sensor.

NOTICE:

Keep the sensor tip and sensor installation hole free from foreign matter.