1.DRAIN BRAKE FLUID
Wash off brake fluid immediately if it comes in contact with any painted surface.
2.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
3.REMOVE BRAKE BOOSTER ASSEMBLY
Disconnect the vacuum hose.
Remove the check valve and grommet from the brake booster.
| *1 | Brake Pedal Return Spring |
| *2 | Clevis Pin |
| *3 | Clip |
Remove the return spring, clip and clevis pin.
Loosen the push rod clevis lock nut.
Remove the 4 nuts and push rod clevis.
Pull out the booster and gasket.