Home › Brake › BRAKE (REAR) › REAR BRAKE FLEXIBLE HOSE
RM1880E _54 Brake _013229 BRAKE (REAR) _0068572 REAR BRAKE FLEXIBLE HOSE A

BRAKE (REAR)  REAR BRAKE FLEXIBLE HOSE  INSTALLATION  


PROCEDURE

Hide 1.INSTALL REAR BRAKE TUBE FLEXIBLE HOSE

a.

Attach a new clip to the flexible hose.


b.

Connect the flexible hose to the 3-way.

Torque:
23 N*m (235 kgf*cm, 17 ft.*lbf)


c.

Using a union nut wrench, connect the flexible hose to the brake tube while holding the flexible hose with a wrench.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not bend or damage the brake tube.

·

Do not allow any foreign matter such as dirt and dust to enter the brake tube and 3-way from the connecting points.

·

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).




Hide 3.BLEED AIR FROM CLUTCH LINE (for Manual Transmission)