Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP
RM1880E _55 Steering _013231 POWER ASSIST SYSTEMS _0068578 VANE PUMP A

POWER ASSIST SYSTEMS  VANE PUMP  INSTALLATION  


PROCEDURE

Hide 1.INSTALL VANE PUMP ASSEMBLY

a.

Install the vane pump with the 2 bolts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


b.

Connect the connector to the oil pressure switch.


Hide 2.CONNECT PRESSURE FEED TUBE ASSEMBLY

a.

Install a new gasket and the pressure feed tube to the vane pump with the union bolt.

Torque:
49 N*m (500 kgf*cm, 36 ft.*lbf)

HINT:

Make sure that the stopper of the pressure feed tube touches the front housing.



Hide 3.CONNECT RETURN HOSE

a.

Connect the hose with the clip.


Hide 5.ADD POWER STEERING FLUID

Hide 7.CHECK FOR FLUID LEAKS