This circuit provides power to the radio receiver assembly.
Inspect the fuses for circuits related to this system before performing the following procedure.
Disconnect the G5 radio receiver assembly connector.
| *a | Front view of wire harness connector
(to Radio Receiver Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G5-7 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G5-4 (B) - Body ground | Always | 11 to 14 V |
| G5-3 (ACC) - Body ground | Ignition switch ACC |
| Proceed to |
|---|
| OK |
| NG |
OK
NG