Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)
RM1880E _56 Audio / Visual / Telematics _013234 AUDIO / VIDEO _0068593 AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) C

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)  CB-43  USB Device Class/Protocol Error  CB-44  USB File System Error  CB-50  iPod Malfunction  CB-51  iPod Protocol Error  CB-7D  iPod Protocol Unsupported  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area Note
CB-43 USB Device Class/Protocol Error A non-mass-storage class or USB device with an incompatible protocol is connected.
·

USB device

·

Radio receiver assembly


USB Audio System
CB-44 USB File System Error An incompatible file system or USB device with a corrupted or incompatible File Allocation Table (FAT) is connected.
·

USB device

·

Radio receiver assembly


USB Audio System
CB-50 iPod Malfunction "iPod" malfunction
·

"iPod"

·

Radio receiver assembly


USB Audio System
CB-51 iPod Protocol Error An "iPod" with unsupported firmware is connected.
·

"iPod"

·

Radio receiver assembly


USB Audio System
CB-7D iPod Protocol Unsupported An unsupported model of "iPod" is connected.
·

"iPod"

·

Radio receiver assembly


USB Audio System

CAUTION / NOTICE / HINT

NOTICE:

The data stored on the USB device or "iPod" may be changed or lost due to malfunctions, repairs, system errors, etc. Therefore, when repairs are to be performed, explain this to the customer and obtain their consent prior to performing repairs.


HINT:

After the inspection is completed, clear the DTCs.


PROCEDURE

1.REPLACE USB DEVICE OR "iPod"
a.

Disconnect the USB device or "iPod" from the stereo jack adapter assembly.


b.

Turn the ignition switch off.

HINT:

When one of these DTCs has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.



c.

Turn the ignition switch to ACC.


d.

Connect a known good USB device or "iPod" to the stereo jack adapter assembly.

HINT:
·

If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.

·

Refer to System Description for compatible formats and versions.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)>SYSTEM DESCRIPTION




Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC

b.

Check for DTCs and check if the same DTC occurs again.

HINT:

If DTCs are output frequently, replace the radio receiver assembly.


OK:

Malfunction disappears.



Result:
Proceed to
OK
NG



OK

USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR USB DEVICE OR "iPod" WAS DEFECTIVE

NG

REPLACE RADIO RECEIVER ASSEMBLY