Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO RECEIVER
RM1880E _56 Audio / Visual / Telematics _013234 AUDIO / VIDEO _0068584 RADIO RECEIVER A

AUDIO / VIDEO  RADIO RECEIVER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL

Hide 4.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 5.REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)

a.
E226341

Remove the 4 screws.


b.

Disconnect all the connectors and remove the radio receiver assembly with bracket.


Hide 6.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type)

a.
E226342

Remove the 4 screws.


b.

Disconnect all the connectors and remove the radio and display receiver assembly with bracket.


Hide 7.REMOVE NO. 1 RADIO BRACKET (for Radio Receiver Type)

a.
E226343

Remove the 3 screws and No. 1 radio bracket from the radio receiver.


Hide 8.REMOVE NO. 1 RADIO BRACKET (for Radio and Display Type)

a.
E226344

Remove the 4 screws and No. 1 radio bracket from the radio and display receiver.


Hide 9.REMOVE NO. 2 RADIO BRACKET (for Radio Receiver Type)

a.
E226345

Remove the 3 screws and No. 2 radio bracket from the radio receiver.


Hide 10.REMOVE NO. 2 RADIO BRACKET (for Radio and Display Type)

a.
E226346

Remove the 4 screws and No. 2 radio bracket from the radio and display receiver.