| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| CB-45 | USB Communication Error | A communication error with USB device. | ·
USB device ·
Radio receiver assembly |
USB Audio System |
| CB-46 | iPod Control Error | An "iPod" control software malfunction. | ·
"iPod" ·
Radio receiver assembly |
USB Audio System |
| CB-47 | iPod Communication Error | A communication error with "iPod". | ·
"iPod" ·
Radio receiver assembly |
USB Audio System |
The data stored on the USB device or "iPod" may be changed or lost due to malfunctions, repairs, system errors, etc. Therefore, when repairs are to be performed, explain this to the customer and obtain their consent prior to performing repairs.
After the inspection is completed, clear the DTCs.
Disconnect the USB device or "iPod" from the stereo jack adapter assembly.
Turn the ignition switch off.
When one of these DTCs has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.
Turn the ignition switch to ACC.
Connect a known good USB device or "iPod" to the stereo jack adapter assembly.
If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs and check if the same DTC occurs again.
If DTCs are output frequently, replace the radio receiver assembly.
Malfunction disappears.
| Proceed to |
|---|
| OK |
| NG |
OK
NG