Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)
RM1880E _56 Audio / Visual / Telematics _013234 AUDIO / VIDEO _0068593 AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)  USB Audio System Recognition/Play Error  


CAUTION / NOTICE / HINT

NOTICE:

The data stored on the USB device or "iPod" may be changed or lost due to malfunctions, repairs, system errors, etc. Therefore, when repairs are to be performed, explain this to the customer and obtain their consent prior to performing repairs.


·

When a large amount of data is in a USB device, it may take a while to begin to play.

·

When using a USB device, files that are protected by copyright cannot be played.

·

When files are not played in the sorted order, perform the following procedure before inspection.

1.

Add numbers in front of the file names.

2.

Put the files in a folder and copy the folder data to the USB device.



PROCEDURE

1.CHECK USB DEVICE OR "iPod"
a.

Disconnect the USB device or "iPod" from the stereo jack adapter assembly.


b.

Check if playable files are present on the USB device or "iPod".

HINT:

Refer to System Description for playable files.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)>SYSTEM DESCRIPTION



c.

Check if the USB device format or "iPod" version is compatible.

HINT:

Refer to System Description for compatible formats and versions.


Result:
Result Proceed to
No playable files exist, or device format or version is incompatible A
Playable files exist, and device format or version is compatible B




A

USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR NO PLAYABLE FILES PRESENT

B

2.FORMAT USB DEVICE OR RESTORE "iPod" AND RECHECK
2.FORMAT USB DEVICE OR RESTORE "iPod" AND RECHECK
a.

Delete all files in the USB device or "iPod" and format/restore it.

NOTICE:

Formatting a USB device or restoring an "iPod" clears all files on the device.

Make sure that backup data is available before performing this operation.



b.

Save the data again and check if it can be played on the in-vehicle device.

OK:

Malfunction disappears.



Result:
Proceed to
OK
NG



OK

END

NG

3.REPLACE USB DEVICE OR "iPod"
3.REPLACE USB DEVICE OR "iPod"
a.

Turn the ignition switch off.


b.

Turn the ignition switch to ACC.


c.

Connect a known good USB device or "iPod" to the stereo jack adapter.

HINT:
·

If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.

·

Refer to System Description for compatible formats and versions.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)>SYSTEM DESCRIPTION




Result:
Proceed to
NEXT



NEXT

4.CHECK USB DEVICE OR "iPod"
4.CHECK USB DEVICE OR "iPod"
a.

Check if the USB device or "iPod" is recognized by the radio receiver, or if information, such as track, artist and album names, is displayed on the screen.

OK:

USB device or "iPod" is recognized or track information, such as track, artist and album names, is displayed.



Result:
Proceed to
OK
NG



OK

USB DEVICE OR "iPod" WAS INCOMPATIBLE OR DEFECTIVE

NG