Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type)
RM1880E _56 Audio / Visual / Telematics _013234 AUDIO / VIDEO _0068594 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  Radio Broadcast cannot be Received (Bad Reception)  


PROCEDURE

1.CHECK IF RADIO AUTO-SEARCH FUNCTIONS PROPERLY
a.

Perform the auto-search of the radio and check that it functions normally.

OK:

Radio auto-search functions normally.



Result:
Proceed to
OK
NG



OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

2.CHECK OPTIONAL COMPONENTS
2.CHECK OPTIONAL COMPONENTS
a.

Check if the telephone antenna or other optional components are installed.

OK:

Optional component(s) installed.


NOTICE:

Do not remove any optional components installed by the customer without his or her consent.



Result:
Proceed to
OK
NG



OK

EFFECT FROM OPTIONAL COMPONENTS

NG

3.CHECK ANTENNA FOR NOISE PRODUCTION
3.CHECK ANTENNA FOR NOISE PRODUCTION
a.

With the ignition switch ACC, turn on the radio and choose the AM mode.


b.

Place the tip of a screwdriver on the antenna and check that noise is heard from the speakers.

OK:

Noise is heard.



Result:
Proceed to
OK
NG



OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

4.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY (ANTENNA)
4.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY (ANTENNA)
a.
E159266

Disconnect the antenna connector from the radio and display receiver assembly.


b.

With the radio and display receiver assembly connector connected, turn the ignition switch to ACC.


c.

Turn on the radio and choose the AM mode.


d.

Place a flat-head screwdriver or a piece of metal, such as a thin wire, on the antenna jack of the radio and display receiver assembly. Check that noise is heard from the speakers.

OK:

Noise is heard.



Result:
Proceed to
OK
NG



OK

ANTENNA ASSEMBLY IS DEFECTIVE

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY