Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type)
RM1880E _56 Audio / Visual / Telematics _013234 AUDIO / VIDEO _0068594 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  Steering Pad Switch Circuit  


DESCRIPTION

This circuit sends an operation signal from the steering pad switch assembly to the radio and display receiver assembly.

If there is an open in the circuit, the audio system cannot be operated using the steering pad switch assembly.

If there is a short in the circuit, the same condition as when the switch is continuously depressed occurs.

Therefore, the radio and display receiver assembly cannot be operated using the steering pad switch assembly, and the radio and display receiver assembly itself cannot function.

WIRING DIAGRAM

C240175
5.792,2.833 6.01,3.031 0.219,0.198 10 false 22 5.802,1.823 6.031,2.031 0.229,0.208 10 false 23 5.802,0.823 6.01,1.021 0.208,0.198 10 false 21 5.5,2.833 5.677,3.01 0.177,0.177 10 false 5 4.646,2.833 4.844,3.042 0.198,0.208 10 false 9 5.5,1.823 5.677,2 0.177,0.177 10 false 4 4.646,1.833 4.854,2.021 0.208,0.188 10 false 8 5.5,0.823 5.677,1.042 0.177,0.219 10 false 6 4.729,3.563 5.042,3.76 0.313,0.198 10 false G12 5.875,3.563 6.25,3.75 0.375,0.188 10 false G127 2.708,2.125 3.198,2.354 0.49,0.229 10 false MODE 6.052,2.906 6.427,3.104 0.375,0.198 10 false SW2 6.052,1.906 6.438,2.094 0.385,0.188 10 false SWG 6.063,0.896 6.417,1.115 0.354,0.219 10 false SW1 4.979,2.833 5.313,3.031 0.333,0.198 10 false AU2 4.979,1.833 5.375,2.052 0.396,0.219 10 false EAU 4.979,0.833 5.344,1.042 0.365,0.208 10 false AU1 2.75,1.115 3.219,1.333 0.469,0.219 10 false Seek+ 2.135,1.115 2.594,1.333 0.458,0.219 10 false Seek- 1.99,2.125 2.604,2.375 0.615,0.25 10 false On Hook 1.323,2.125 1.938,2.365 0.615,0.24 10 false Off Hook 1.573,1.115 1.917,1.354 0.344,0.24 10 false Vol+ 0.938,1.115 1.313,1.396 0.375,0.281 10 false Vol- 4.583,0.823 4.813,1.063 0.229,0.24 10 false 10 5.885,3.74 7.083,4.198 1.198,0.458 10 false Radio and Display Receiver Assembly 4.729,3.729 5.667,4.167 0.938,0.438 10 false Spiral Cable Sub-assembly 1.333,3.76 3.292,4.021 1.958,0.26 10 false Steering Pad Switch Assembly 1.333,3.573 1.604,3.781 0.271,0.208 10 false z3

CAUTION / NOTICE / HINT

CAUTION:

The vehicle is equipped with an SRS (Supplemental Restraint System) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precautionary notice for the SRS (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

1.INSPECT STEERING PAD SWITCH ASSEMBLY
a.

Remove the steering pad switch assembly.

Click hereSteering>STEERING COLUMN>STEERING PAD SWITCH>REMOVAL


b.

Measure the resistance according to the value(s) in the table below.

C237719
3.406,0.094 3.74,0.313 0.333,0.219 3.656,0.833 4.135,0.417 4.135,0.417 4.25,0.417 true 3.719,0.833 4.115,0.656 4.115,0.656 4.229,0.656 true 3.531,0.833 3.177,0.552 3.177,0.552 3.063,0.552 true 2.052,1.427 1.927,0.573 1.927,0.573 1.833,0.573 true 1.729,1.49 1.458,0.844 1.458,0.844 1.396,0.844 true 1.667,1.719 1.104,1.24 1.104,1.24 0.99,1.24 true 2.094,1.792 2.531,2.26 2.531,2.26 2.646,2.26 true 2.146,2.521 2.5,2.823 2.5,2.823 2.625,2.823 true 2.104,2.771 1.708,3.104 1.708,3.104 1.625,3.104 true 1.573,2.104 1.438,2.521 1.438,2.521 1.354,2.521 true 1.656,0.49 1.969,0.646 0.313,0.156 10 false *1 1.229,0.75 1.542,0.906 0.313,0.156 10 false *2 0.833,1.156 1.146,1.313 0.313,0.156 10 false *3 2.698,2.167 3.01,2.323 0.313,0.156 10 false *4 1.188,2.448 1.5,2.604 0.313,0.156 10 false *5 2.677,2.75 2.99,2.906 0.313,0.156 10 false *6 1.458,3.021 1.771,3.177 0.313,0.156 10 false *7 3.5,0.125 3.771,0.323 0.271,0.198 10 false z3 2.74,0.469 3.104,0.729 0.365,0.26 10 false EAU 4.292,0.333 4.719,0.615 0.427,0.281 10 false AU2 4.302,0.583 4.729,0.865 0.427,0.281 10 false AU1
*1 Volume+ Switch *2 Volume- Switch
*3 Seek- Switch *4 Seek+ Switch
*5 MODE Switch *6 On Hook Switch
*7 Off Hook Switch - -


Standard Resistance:
Tester Connection Switch Condition Specified Condition
z3-10 (AU1) - z3-8 (EAU) No switch is pushed 95 to 105 kΩ
Seek+ switch is pushed Below 2.5 Ω
Seek- switch is pushed 312.6 to 345.5 Ω
Volume+ switch is pushed 950 to 1050 Ω
Volume- switch is pushed 2954.5 to 3265.5 Ω
z3-9 (AU2) - z3-8 (EAU) No switch is pushed 95 to 105 kΩ
MODE switch is pushed Below 2.5 Ω
On Hook switch is pushed 312.6 to 345.5 Ω
Off Hook switch is pushed 950 to 1050 Ω



Result:
Proceed to
OK
NG



OK

2.INSPECT SPIRAL CABLE SUB-ASSEMBLY

NG

REPLACE STEERING PAD SWITCH ASSEMBLY

2.INSPECT SPIRAL CABLE SUB-ASSEMBLY
a.

Remove the spiral cable sub-assembly.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>REMOVAL


b.

Measure the resistance according to the value(s) in the table below.

C282256
1.563,1 1.708,0.708 true 1.958,0.979 1.823,0.719 true 2.375,0.99 1.917,0.708 true 5.771,2.406 5.292,2.042 true 5.469,2.406 5.208,2.031 true 4.938,2.396 5.135,2.031 true 1.375,0.156 1.688,0.354 0.313,0.198 10 false *a 4.604,1.448 4.917,1.646 0.313,0.198 10 false *b 1.438,1.021 1.896,1.219 0.458,0.198 10 false AU1 1.875,1.021 2.333,1.219 0.458,0.198 10 false AU2 2.302,1.021 2.76,1.219 0.458,0.198 10 false EAU 5.75,2.417 6.208,2.615 0.458,0.198 10 false AU1 5.333,2.417 5.792,2.615 0.458,0.198 10 false AU2 4.792,2.417 5.25,2.615 0.458,0.198 10 false EAU
*a Steering Pad Switch Side *b Vehicle Side


Standard Resistance:
Tester Connection Condition Specified Condition
8 (EAU) - 4 (EAU) Spiral cable is turned 2.5 rotations counterclockwise Below 1 Ω
Spiral cable is centered
Spiral cable is turned 2.5 rotations clockwise
10 (AU1) - 6 (AU1) Spiral cable is turned 2.5 rotations counterclockwise
Spiral cable is centered
Spiral cable is turned 2.5 rotations clockwise
9 (AU2) - 5 (AU2) Spiral cable is turned 2.5 rotations counterclockwise
Spiral cable is centered
Spiral cable is turned 2.5 rotations clockwise


CAUTION:

The spiral cable is an important part of the SRS airbag system. Incorrect removal or installation of the spiral cable may prevent the airbag from deploying. Be sure to read the Precaution for the SRS.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER - SPIRAL CABLE)

NG

REPLACE SPIRAL CABLE SUB-ASSEMBLY

3.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER - SPIRAL CABLE)
a.

Disconnect the G127 radio and display receiver assembly connector.


b.

Disconnect the G12 spiral cable sub-assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G127-21 (SW1) - G12-6 (AU1) Always Below 1 Ω
G127-22 (SW2) - G12-5 (AU2)
G127-23 (SWG) - G12-4 (EAU)
G127-21 (SW1) - Body ground Always 10 kΩ or higher
G127-22 (SW2) - Body ground
G127-23 (SWG) - Body ground



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR