Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE
RM1880E _58 Vehicle Interior _013242 SUPPLEMENTAL RESTRAINT SYSTEMS _0068637 SPIRAL CABLE A

SUPPLEMENTAL RESTRAINT SYSTEMS  SPIRAL CABLE  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.REMOVE STEERING WHEEL ASSEMBLY

Hide 2.REMOVE LOWER INSTRUMENT CLUSTER FINISH PANEL

Hide 3.REMOVE LOWER STEERING COLUMN COVER

Hide 4.REMOVE UPPER STEERING COLUMN COVER

Hide 5.REMOVE SPIRAL CABLE SUB-ASSEMBLY

a.
B290000

Disconnect the connectors.

NOTICE:

When handling the airbag connector, do not damage the airbag wire harness.



b.

Detach the 3 claws and remove the spiral cable sub-assembly.

NOTICE:
·

Do not replace the spiral cable sub-assembly when the ignition switch is ON and the battery cable is connected.

·

Do not rotate the spiral cable sub-assembly when the ignition switch is ON and the battery cable is connected.

·

Make sure the steering wheel assembly is installed and centered before rotating the steering angle sensor when performing steering angle sensor operation inspections (inspecting for abnormal noise, diagnosis inspections, etc.).

·

Do not remove the steering angle sensor from the spiral cable sub-assembly.