Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR
RM1880E _56 Audio / Visual / Telematics _013235 PARK ASSIST / MONITORING _0068596 ULTRASONIC SENSOR A

PARK ASSIST / MONITORING  ULTRASONIC SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL NO. 1 ULTRASONIC SENSOR RETAINER

HINT:

Use the same procedure to install the No. 1 ultrasonic sensor retainer on the other side.


a.
E172297

Align the keyway of the ultrasonic sensor retainer and the protrusion of the rear bumper cover, as shown in the illustration.


b.
E173628

Attach the 2 claws to install the ultrasonic sensor retainer to the rear bumper cover.

NOTICE:
·

Do not damage the rear bumper cover with the protrusion of the ultrasonic sensor retainer when installing the retainer.

·

Firmly push in the No. 1 ultrasonic sensor retainer so that there is no gap between the retainer and the surface of the rear bumper cover.

·

If there is a gap between the No. 1 ultrasonic sensor retainer and the rear bumper cover surface, push in the No. 1 ultrasonic sensor retainer. Do not push the No. 1 ultrasonic sensor.




Hide 2.INSTALL NO. 1 ULTRASONIC SENSOR

HINT:

Use the same procedure to install the No. 1 ultrasonic sensor on the other side.


a.
E172296

Attach the 2 claws to install the No. 1 ultrasonic sensor.


b.

Connect the connector.

NOTICE:

If there is a gap between the No. 1 ultrasonic sensor retainer and the rear bumper cover surface, push in the No. 1 ultrasonic sensor retainer. Do not push the No. 1 ultrasonic sensor.



Hide 3.INSTALL REAR BUMPER COVER

a.

Install the rear bumper cover (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER>INSTALLATION).