Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR
RM1880E _56 Audio / Visual / Telematics _013235 PARK ASSIST / MONITORING _0068596 ULTRASONIC SENSOR A

PARK ASSIST / MONITORING  ULTRASONIC SENSOR  REMOVAL  


PROCEDURE

Hide 1.REMOVE REAR BUMPER COVER

a.

Remove the rear bumper cover (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER>REMOVAL).


Hide 2.REMOVE NO. 1 ULTRASONIC SENSOR

HINT:

Use the same procedure to remove the No. 1 ultrasonic sensor on the other side.


a.

Disconnect the connector.


b.
E173572

While pushing down on the lever with a finger to release the claw on the top of the sensor, detach the claw on the other side to remove the No. 1 ultrasonic sensor.

HINT:

The type of claw on the top and the type of claw on the bottom of the sensor are different. Observe the claws carefully before removing the sensor.



Hide 3.REMOVE NO. 1 ULTRASONIC SENSOR RETAINER

a.
E173628

Detach the 2 claws and remove the No. 1 ultrasonic sensor retainer from the rear bumper cover.