The display signal from the rear television camera assembly transmits to the radio and display receiver assembly.
Disconnect the G2 radio and display receiver assembly connector.
Disconnect the V9 rear television camera assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G2-7 (CA+) - V9-4 (CB+) | Always | Below 1 Ω |
| G2-8 (V+) - V9-2 (CV+) | Always | Below 1 Ω |
| G2-15 (CGND) - V9-3 (CGND) | Always | Below 1 Ω |
| G2-16 (V-) - V9-1 (CV-) | Always | Below 1 Ω |
| G2-7 (CA+) - Body ground | Always | 10 kΩ or higher |
| G2-8 (V+) - Body ground | Always | 10 kΩ or higher |
| G2-15 (CGND) - Body ground | Always | 10 kΩ or higher |
| G2-16 (V-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the G2 radio and display receiver assembly connector.
| *a | Component without harness connected
(Radio and Display Receiver Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G2-16 (V-) - Body ground | Always | Below 1 Ω |
| G2-15 (CGND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the V9 rear television camera assembly connector.
| *a | Front view of wire harness connector
(to Rear Television Camera Assembly) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| V9-4 (CB+) - V9-3 (CGND) | Ignition switch ON, shift lever in R | 5.5 to 7.05 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Using an oscilloscope, check the waveform.
| *a | Component with harness connected
(Radio and Display Receiver Assembly) |
*b | Waveform 1 |
| *c | Waveform 2 | *d | Synchronized Signal |
| *e | Video Waveform | - | - |
A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the radio and display receiver assembly with the connector connected.
| Item | Content |
|---|---|
| Terminal No. (Symbol) | G2-8 (V+) - G2-16 (V-) |
| Tool Setting | 0.2 V/DIV., 50 μs/DIV. |
| Condition | Waveform 1: Ignition switch ON, shift lever in R
Waveform 2: Ignition switch ON, shift lever in R, screen blacked out by covering camera lens |
Waveform is as shown in the illustration.
The video waveform changes according to the image sent by the rear television camera assembly.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>REAR VIEW MONITOR SYSTEM>PROBLEM SYMPTOMS TABLE
NG