Home › Power Source / Network › 2TR-FE BATTERY / CHARGING › GENERATOR
RM1880E _57 Power Source / Network _013236 2TR-FE BATTERY / CHARGING _0068603 GENERATOR A

2TR-FE BATTERY / CHARGING  GENERATOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from battery terminal notice before proceeding with work. (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION)


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 3.REMOVE INTAKE AIR CONNECTOR AND AIR CLEANER ASSEMBLY

Hide 5.REMOVE GENERATOR ASSEMBLY

a.
A099681

Detach the terminal cap.


b.

Remove the nut, bolt and disconnect generator wire.


c.

Disconnect the generator connector.


d.

Remove the 2 bolts and generator.