Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM(w/ Theft Deterrent System)
RM1880E _58 Vehicle Interior _013237 DOOR LOCK _0068605 WIRELESS DOOR LOCK CONTROL SYSTEM(w/ Theft Deterrent System) J

DOOR LOCK  WIRELESS DOOR LOCK CONTROL SYSTEM(w/ Theft Deterrent System)  No Answer-Back  


DESCRIPTION

In this case, wireless control functions are normal but one ore more of the following may occur.

·

The hazard warning light and side turn signal answer-back function is not normal (the theft warning ECU's turn signal flasher output may be malfunctioning).

·

The security horn answer-back function normal (the security horn signal outpu0t may be malfunction)*.


HINT:

*: The security horn assembly applies only if the wireless answer-back function has been customized so that the hazard warning lights and side turn signal lights flash and the security horn assembly sounds.


WIRING DIAGRAM

B276573
5.49,0.302 5.792,0.458 0.302,0.156 10 false SH- 5.198,0.219 5.396,0.375 0.198,0.156 10 false 26 1.604,0.51 1.729,0.667 0.125,0.156 10 false 1 2.115,1.688 2.24,1.844 0.125,0.156 10 false 8 1.938,0.635 2.25,0.792 0.313,0.156 10 false A25 1.938,0.792 3.458,0.979 1.521,0.188 10 false Security Horn Assembly 5.021,2.052 5.406,2.208 0.385,0.156 10 false G124 5.021,2.198 6.927,2.385 1.906,0.188 10 false Theft Warning ECU Assembly 0.875,2.125 1.24,2.281 0.365,0.156 10 false G117 0.875,2.292 2.771,2.479 1.896,0.188 10 false Turn Signal Flasher Assembly 0.635,2.927 2.25,3.313 1.615,0.385 10 false to Hazard Warning Signal Switch Assembly 5.49,1.771 5.896,1.927 0.406,0.156 10 false HAZD 1.719,1.781 2.052,1.938 0.333,0.156 10 false HAZ 5.198,1.688 5.396,1.844 0.198,0.156 10 false 23

CAUTION / NOTICE / HINT

NOTICE:

When replacing the theft warning ECU assembly, refer to the registration procedures (See page Vehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM(w/ Theft Deterrent System)>REGISTRATION).


PROCEDURE

1.CHECK WIRELESS DOOR LOCK CONTROL FUNCTION
a.

Check the wireless door lock functions by operating the transmitter switches.

Result:
Result Proceed to
Only hazard warning light and side turn signal light answer-back does not occur A
Only security horn answer-back does not occur* B


HINT:

*: The security horn assembly applies only if the wireless answer-back function has been customized so that the hazard warning lights and side turn signal lights flash and the security horn assembly sounds.




A

2.CHECK HAZARD WARNING LIGHT OPERATION

B

2.CHECK HAZARD WARNING LIGHT OPERATION
a.

Check that the hazard warning lights and side turn signal lights flash when the hazard warning signal switch assembly is pressed.

OK:

Hazard warning lights and side turn signal lights flash when hazard warning signal switch assembly is pressed.



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU - TURN SIGNAL FLASHER)

NG

3.CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU - TURN SIGNAL FLASHER)
a.

Disconnect the G124 theft warning ECU assembly connector.


b.

Disconnect the G117 turn signal flasher assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G124-23 (HAZD) - G117-8 (HAZ) Always Below 1 Ω
G124-23 (HAZD) or G117-8 (HAZ) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR