Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT WARNING ECU
RM1880E _58 Vehicle Interior _013238 THEFT DETERRENT / KEYLESS ENTRY _0068621 THEFT WARNING ECU A

THEFT DETERRENT / KEYLESS ENTRY  THEFT WARNING ECU  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE COMBINATION METER ASSEMBLY

Hide 4.REMOVE THEFT WARNING ECU ASSEMBLY

a.
E226508

Disconnect the connector.


b.

Remove the bolt and theft warning ECU assembly.