The transponder key coil receives key code signals from the transponder chip in the key grip. The coil is built into the transponder key amplifier, which amplifies the key code signals and outputs the signals to the transponder key ECU assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Note |
|---|---|---|---|---|---|
| B2784 | Antenna Coil Open / Short | The antenna coil built into the transponder key amplifier is open or shorted (determined by communication with transponder key ECU assembly) (1 trip detection logic*).
·
Terminal VC5, TEXT or CODE is open. ·
The antenna coil built into the transponder key amplifier is open. |
Transponder key amplifier | Transponder Key ECU Assembly | DTC Output Confirmation Operation
Insert the key into the ignition key cylinder. |
*: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Engine cannot be started. | - |
| DTC Code | Data List and Active Test |
|---|---|
| B2784 | Antenna Coil Status |
After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.
Clear the DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR
DTC B2784 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG