Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › TRANSPONDER KEY AMPLIFIER
RM1880E _58 Vehicle Interior _013238 THEFT DETERRENT / KEYLESS ENTRY _0068618 TRANSPONDER KEY AMPLIFIER A

THEFT DETERRENT / KEYLESS ENTRY  TRANSPONDER KEY AMPLIFIER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE STEERING COLUMN LOWER COVER

Hide 4.REMOVE STEERING COLUMN UPPER COVER

Hide 5.REMOVE TRANSPONDER KEY AMPLIFIER

a.
E225100

Using a screwdriver, widen the claw attached to the upper bracket by approximately 1.0 mm (0.039 in.).


b.

Pull out the transponder key amplifier with the claw open.


c.

Disconnect the connector and remove the transponder key amplifier.