If an ECM that is incompatible with the engine immobiliser system is installed, the ECM stores this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Note |
|---|---|---|---|---|---|
| B279C | Theft Deterrent System Presence Detection | An ECM that is incompatible with the engine immobiliser system is installed (1 trip detection logic*). | ECM | ECM | DTC Output Confirmation Operation
Check for DTCs. |
*: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Engine cannot be started. | - |
| DTC Code | Data List and Active Test |
|---|---|
| B279C | - |
When replacing the ECM, refer to the Service Bulletin.
After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.
Replace the current ECM with the proper ECM.
Click hereEngine / Hybrid System>2TR-FE ENGINE CONTROL>ECM>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT