1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
4.REMOVE ECM
Disconnect the 4 connectors.
Remove the bolt, 2 nuts and ECM.
5.REMOVE NO. 1 ECM BRACKET
Remove the 2 screws and No. 1 ECM bracket.
6.REMOVE NO. 2 ECM BRACKET
Remove the 2 screws and No. 2 ECM bracket.