Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM
RM1880E _58 Vehicle Interior _013238 THEFT DETERRENT / KEYLESS ENTRY _0068616 THEFT DETERRENT SYSTEM J

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM  Engine Hood Courtesy Switch Circuit  


DESCRIPTION

The security courtesy switch is installed together with the hood lock assembly. This switch turns off when the engine hood is opened and turns on when the engine hood is closed.

WIRING DIAGRAM

B281448
2.583,1.333 4.344,1.833 1.76,0.5 10 false Hood Lock Assembly (Security Courtesy Switch) 2.583,1.167 3.01,1.417 0.427,0.25 10 false A26 5.083,1.833 7,2.083 1.917,0.25 10 false Theft Warning ECU Assembly 5.073,1.667 5.438,1.917 0.365,0.25 10 false G124 5.667,0.875 6.219,1.073 0.552,0.198 10 false DSWH 5.469,0.75 5.646,0.948 0.177,0.198 10 false 9 3.854,0.75 4.094,0.948 0.24,0.198 10 false 1 2.854,0.76 3.146,0.958 0.292,0.198 10 false 2

PROCEDURE

1.INSPECT HOOD LOCK ASSEMBLY (SECURITY COURTESY SWITCH)
a.

Remove the hood lock assembly (security courtesy switch).

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE HOOD COURTESY SWITCH>REMOVAL


b.

Inspect the hood lock assembly (security courtesy switch).

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE HOOD COURTESY SWITCH>INSPECTION


Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (HOOD LOCK - THEFT WARNING ECU AND BODY GROUND)

NG

REPLACE HOOD LOCK ASSEMBLY (SECURITY COURTESY SWITCH)

2.CHECK HARNESS AND CONNECTOR (HOOD LOCK - THEFT WARNING ECU AND BODY GROUND)
a.

Disconnect the A26 hood lock assembly (security courtesy switch) connector.


b.

Disconnect the G124 theft warning ECU assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A26-1 - G124-9 (DSWH) Always Below 1 Ω
A26-1 or G124-9 (DSWH) - Body ground Always 10 kΩ or higher
A26-2 - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR