Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM
RM1880E _58 Vehicle Interior _013238 THEFT DETERRENT / KEYLESS ENTRY _0068616 THEFT DETERRENT SYSTEM J

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM  Security Horn Circuit  


DESCRIPTION

When the theft deterrent system is operating, a relay in the theft warning ECU assembly turns ON and OFF continuously at 0.4 seconds intervals, causing the security horn assembly to sound.

WIRING DIAGRAM

B275964
5.219,0.927 5.583,1.198 0.365,0.271 10 false SH- 0.833,1.167 1.24,1.365 0.406,0.198 10 false A25 0.833,1.333 1.698,2.021 0.865,0.688 10 false Security Horn Assembly 4.667,1.51 5.021,1.75 0.354,0.24 10 false G124 4.667,1.667 6.688,2 2.021,0.333 10 false Theft Warning ECU Assembly 4.948,0.823 5.24,1.01 0.292,0.188 10 false 26 1.99,1.198 2.188,1.417 0.198,0.219 10 false 1

CAUTION / NOTICE / HINT

NOTICE:

When replacing the theft warning ECU assembly, refer to the registration procedures (See page Vehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM(w/ Theft Deterrent System)>REGISTRATION).


PROCEDURE

1.INSPECT SECURITY HORN ASSEMBLY

b.
B119759

Apply battery voltage to the horn and check operation of the horn.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 1
Battery negative (-) → Horn bracket
Horn sounds



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU - SECURITY HORN)

NG

2.CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU - SECURITY HORN)
a.

Disconnect the G124 theft warning ECU assembly connector.


b.

Disconnect the A25 security horn assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G124-26 (SH-) - A25-1 Always Below 1 Ω
G124-26 (SH-) or A25-1 - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR