Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM
RM1880E _58 Vehicle Interior _013240 METER / GAUGE / DISPLAY _0068630 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Engine Coolant Temperature Gauge Malfunction  


DESCRIPTION

In this circuit, the meter CPU receives engine coolant temperature signals from the ECM. The meter CPU displays engine coolant temperature that is calculated based on the data received from the ECM.

WIRING DIAGRAM

E273791
0.813,1.573 1.313,1.823 0.5,0.25 10 false THWO 0.24,2.573 0.74,2.823 0.5,0.25 10 false G88 0.615,2.74 1.115,2.99 0.5,0.25 10 false ECM 1.365,1.479 1.667,1.75 0.302,0.271 10 false 14 5.74,1.479 6.042,1.75 0.302,0.271 10 false 4 5.979,1.573 6.479,1.823 0.5,0.25 10 false TEMP 5.896,2.594 6.396,2.844 0.5,0.25 10 false G19 5.896,2.781 7.104,3.25 1.208,0.469 10 false Combination Meter Assembly

PROCEDURE

1.CHECK FOR DTC
a.

Check for DTCs of the SFI system.

Click hereEngine / Hybrid System>2TR-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR

Powertrain > Engine > Trouble Codes
50001 61
Result:
Result Proceed to
DTC is not output A
DTC is output B




A

2.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM)

B

2.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM)
a.

Disconnect the G19 combination meter assembly connector.


b.

Disconnect the G88 ECM connector.


c.

Measure the resistance of the wire harness side connectors.

Standard Resistance:
Tester Connection Condition Specified Condition
G19-4 (TEMP) - G88-14 (THWO) Always Below 1 Ω
G19-4 (TEMP) or G88-14 (THWO) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.REPLACE COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.REPLACE COMBINATION METER ASSEMBLY
a.

Replace the combination meter assembly with a new or normally functioning one.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL

OK:

The operation of the engine coolant temperature gauge returns to normal.



Result:
Proceed to
OK
NG



OK

END (COMBINATION METER ASSEMBLY IS DEFECTIVE)

NG