Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD
RM1880E _58 Vehicle Interior _013242 SUPPLEMENTAL RESTRAINT SYSTEMS _0068636 STEERING PAD A

SUPPLEMENTAL RESTRAINT SYSTEMS  STEERING PAD  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE LOWER NO. 3 STEERING WHEEL COVER

a.
B277147
2.719,1.521 1.865,0.927 true 2.677,1.385 2.833,1.563 0.156,0.177 10 false *1
*1 Protective Tape


Using a screwdriver wrapped with protective tape, detach the 2 claws and remove the lower No. 3 steering wheel cover.

HINT:

Protective tape the screwdriver tip before use.



Hide 4.REMOVE LOWER NO. 2 STEERING WHEEL COVER

a.
B278834
0.875,1.5 1.615,0.99 true 0.615,1.479 0.771,1.656 0.156,0.177 10 false *1
*1 Protective Tape


Using a screwdriver wrapped with protective tape, detach the 2 claws and remove the lower No. 2 steering wheel cover.

HINT:

Protective tape the screwdriver tip before use.



Hide 5.REMOVE STEERING PAD

a.
B289998
1.854,2.885 2.156,2.583 true 1.635,2.875 1.792,3.052 0.156,0.177 10 false *1
*1 Screw Case


Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.


b.
B277210

Pull out the steering pad from the steering wheel as shown in the illustration. Then support the steering pad with one hand.

NOTICE:

When removing the steering pad, do not pull the airbag wire harness.



c.

Disconnect the horn connector.


d.

Disconnect the connector and remove the steering pad .

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.