Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM
RM1880E _58 Vehicle Interior _013242 SUPPLEMENTAL RESTRAINT SYSTEMS _0068641 AIRBAG SYSTEM D

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  DTC CHECK / CLEAR  


CHECK DTC (Using SST Check Wire)


a.

Check for DTCs (present trouble code).

i.
C198509
0.135,1.083 0.552,1.333 0.417,0.25 1.563,1.073 1.167,1.698 true 1.792,1.469 1.906,1.729 true 1.583,0.333 1.927,0.646 0.344,0.313 10 false *a 1.969,1.708 2.354,2.021 0.385,0.313 10 false TC 1.031,1.729 1.438,2.052 0.406,0.323 10 false CG 0.219,1.135 0.625,1.458 0.406,0.323 10 false G18
*a Front view of DLC3


Turn the ignition switch to ON and wait for approximately 60 seconds.


ii.

Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

SST
09843-18040  

NOTICE:

Connect the correct terminals to avoid a malfunction.




b.

Check for DTCs (past trouble code).

i.

Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

SST
09843-18040  

NOTICE:

Connect the correct terminals to avoid a malfunction.



ii.

Turn the ignition switch to ON and wait for approximately 60 seconds.



c.

Read the DTCs.

C283256
0.167,0.167 1.938,0.813 1.771,0.646 10 false Normal System Code (without Past Trouble Code): 2.635,0.156 4.219,0.781 1.583,0.625 10 false Normal System Code (with Past Trouble Code): 4.948,0.167 6.458,0.802 1.51,0.635 10 false Trouble Code (Example Codes 11 and 31): 0.042,1.25 0.354,1.448 0.313,0.198 10 false On 0.042,1.615 0.354,1.813 0.313,0.198 10 false Off 2.469,1.25 2.781,1.448 0.313,0.198 10 false On 2.479,1.604 2.792,1.802 0.313,0.198 10 false Off 0.635,1.135 1.385,1.333 0.75,0.198 10 false 0.25 sec. 0.75,1.75 1.5,1.948 0.75,0.198 10 false 0.25 sec. 3.406,1.75 4.156,1.948 0.75,0.198 10 false 0.25 sec. 3.219,1.135 3.969,1.333 0.75,0.198 10 false 0.75 sec. 4.542,1.052 5.25,1.25 0.708,0.198 10 false 0.5 sec. 5.385,0.813 6.094,1.01 0.708,0.198 10 false 2.5 sec. 6.177,0.813 6.885,1.01 0.708,0.198 10 false 4.0 sec. 4.729,1.688 5.438,1.885 0.708,0.198 10 false 1.5 sec. 5.104,2.01 5.813,2.208 0.708,0.198 10 false DTC 11 5.74,2.01 6.448,2.208 0.708,0.198 10 false DTC 31 5.99,1.594 6.698,1.792 0.708,0.198 10 false 0.5 sec. 6.656,1.729 7.146,2.01 0.49,0.281 10 false Repeat

i.

Read the blinking patterns of the DTCs. As examples, the blinking patterns for the normal system code and trouble codes 11 and 31 are shown in the illustration.

·

Normal system code indication (without past trouble code):

The light blinks twice per second.

·

Normal system code indication (with past trouble code):

When a past trouble code is stored in the center airbag sensor, the light blinks only once per second.

·

Trouble code indication:

Each digit of a DTC is separated by a 1.5 second pause.


If there is more than 1 code, there is a 2.5 second pause between each code. After all the codes are output, there is a 4.0 second pause, and then all codes are repeated.

HINT:
·

If 2 or more malfunctions are found, the indication begins with the smaller-numbered code.

·

If DTCs are output without connecting the terminals, proceed to "Diagnosis Circuit" (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>TC and CG Terminal Circuit).






CLEAR DTC (Using SST Check Wire)


a.

When the ignition switch is turned off, the DTCs are cleared.

HINT:

Depending on the DTC, the code may not be cleared by turning off the ignition switch. In this case, proceed to the next step.



b.

Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3, and then turn the ignition switch to ON.

SST
09843-18040  


c.

Disconnect terminal TC of the DLC3 within 3 to 10 seconds after the DTCs are output and check that the SRS warning light comes on after 3 seconds.


d.

Within 2 to 4 seconds after the SRS warning light comes on, connect terminals 13 (TC) and 4 (CG) of the DLC3.


e.

Check that the SRS warning light goes off within 2 to 4 seconds after connecting terminals 13 (TC) and 4 (CG) of the DLC3. Then, disconnect terminal 13 (TC) within 2 to 4 seconds after the SRS warning light goes off.


f.

Check that the SRS warning light comes on again within 2 to 4 seconds after disconnecting terminal 13 (TC). Then, reconnect terminals 13 (TC) and 4 (CG) within 2 to 4 seconds after the SRS warning light comes on.


g.

Check that the SRS warning light goes off within 2 to 4 seconds after connecting terminals 13 (TC) and 4 (CG) of the DLC3. Also, check that the normal system code is output within 1 second after the SRS warning light goes off.

If DTCs are not cleared, repeat this procedure until the codes are cleared.

C281352
0.083,0.469 1.094,0.802 1.01,0.333 10 false Ignition Switch 1.396,0.479 1.792,0.802 0.396,0.323 10 false ON 1.396,0.844 1.792,1.167 0.396,0.323 10 false Off 0.073,1.177 1.406,1.594 1.333,0.417 10 false DLC3 (TC and CG) 1.385,1.188 2.385,1.604 1,0.417 10 false Disconnected 1.396,1.573 2.396,1.99 1,0.417 10 false Connected 1.521,2.094 1.917,2.417 0.396,0.323 10 false On 1.531,2.51 1.927,2.833 0.396,0.323 10 false Off 0.083,2.083 1.417,2.5 1.333,0.417 10 false SRS Warning Light* 0.167,2.813 1.5,3.229 1.333,0.417 10 false T1: 0 to ∞ sec. 0.177,3.063 1.51,3.479 1.333,0.417 10 false T2: approx. 6 sec. 0.177,3.333 1.51,3.75 1.333,0.417 10 false T3: 3 to 5 sec. 0.177,3.583 1.51,4 1.333,0.417 10 false T4: 3 to 10 sec. 0.188,3.885 1.521,4.302 1.333,0.417 10 false T5: 2 to 4 sec. 0.177,4.167 1.51,4.583 1.333,0.417 10 false T6: 1 to 5 sec. 0.177,4.448 1.51,4.802 1.333,0.354 10 false T7: within 1 sec. 3.594,1.719 4.135,2.042 0.542,0.323 10 false 0.5 sec. 3.021,1.719 3.563,2.042 0.542,0.323 10 false 0.5 sec. 5.573,1.719 6.208,2.042 0.635,0.323 10 false 0.25 sec. 6.188,1.719 6.875,2.063 0.688,0.344 10 false 0.25 sec. 3.563,2.823 4.104,3.146 0.542,0.323 10 false 1.5 sec. 2.865,3.531 3.177,3.875 0.313,0.344 10 false T2 3.26,3.531 3.573,3.875 0.313,0.344 10 false T3 2.469,3.542 2.781,3.885 0.313,0.344 10 false T1 3.74,3.531 4.052,3.875 0.313,0.344 10 false T4 4.417,3.531 4.729,3.875 0.313,0.344 10 false T6 4.688,3.542 5,3.885 0.313,0.344 10 false T5 4.167,3.531 4.479,3.875 0.313,0.344 10 false T5 4.927,3.531 5.24,3.875 0.313,0.344 10 false T6 5.198,3.542 5.51,3.885 0.313,0.344 10 false T5 5.448,3.531 5.76,3.875 0.313,0.344 10 false T6 5.698,3.531 6.01,3.875 0.313,0.344 10 false T5 5.969,3.531 6.281,3.875 0.313,0.344 10 false T7 2.333,4.125 6.76,4.51 4.427,0.385 10 false *: The past trouble code in the illustration shows DTC 21 as an example.



CHECK DTC (Using the Intelligent Tester)


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / SRS Airbag / Trouble Codes.

Body Electrical > SRS Airbag > Trouble Codes
50001 63


CLEAR DTC (Using the Intelligent Tester)


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / SRS Airbag / Trouble Codes.

Body Electrical > SRS Airbag > Clear DTCs
50002 63

e.

Clear the DTCs.