Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.INSPECT FRONT SEAT INNER BELT ASSEMBLY LH
| *a | Component without harness connected
(Front Seat Inner Belt Assembly LH) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Seat belt is unfastened | Below 1 Ω |
| 1 - 2 | Seat belt is fastened | 1 MΩ or higher |
If the result is not as specified, replace the inner belt assembly LH.
2.INSPECT FRONT SEAT INNER BELT ASSEMBLY RH
Measure the resistance according to the value(s) in the table below.
| *1 | Connector A | *2 | Connector B |
| *a | Component without harness connected
(Front Seat Inner Belt Assembly) |
- | - |
Before performing the buckle switch check, inspect the separate type front seat cushion pad (See page Vehicle Interior>SEAT BELT>OCCUPANT DETECTION SENSOR>INSPECTION) to make sure the occupant detection sensor is functioning normally.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A1 - B1 | Always | Below 1 Ω |
| A2 - B2 | Seat belt is unfastened | Below 1 Ω |
| A2 - B2 | Seat belt is fastened | 1 MΩ or higher |
If the result is not as specified, replace the front seat inner belt assembly RH.