A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
1.INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY LH
| *1 | Protruding Part |
Install the rear No. 1 seat inner belt assembly LH with the bolt.
The anchor part of the seat belt must not overlap the protruding part.
2.INSTALL REAR NO. 1 SEAT RECLINING COVER RH
3.INSTALL REAR NO. 1 SEAT ASSEMBLY LH