1.REMOVE FRONT DOOR SCUFF PLATE LH
2.REMOVE REAR DOOR SCUFF PLATE LH
3.REMOVE FRONT DOOR WEATHERSTRIP LH
Partially remove the front door opening trim LH so that the lower center pillar garnish and center pillar garnish can be removed (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).
4.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
Partially remove the rear door opening trim weatherstrip LH so that the lower center pillar garnish and center pillar garnish can be removed (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).
5.REMOVE LOWER CENTER PILLAR GARNISH LH
Remove the bolt and disconnect the front seat outer belt floor anchor.
Using a screwdriver, detach the 2 claws.
Tape the screwdriver tip before use.
Detach the 2 clips and remove the lower center pillar garnish.
6.REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH
Using a screwdriver, detach the 4 claws and remove the seat belt anchor cover cap.
Tape the screwdriver tip before use.
Remove the bolt and disconnect the front seat outer belt shoulder anchor.
w/o Pretensioner:
Remove the bolt and retractor of the front seat outer belt assembly LH.
w/ Pretensioner:
Disconnect the pretensioner connector as shown in the illustration.
Remove the 2 bolts and seat belt.
7.REMOVE CENTER PILLAR GARNISH LH
8.REMOVE SHOULDER BELT ANCHORAGE PLATE COVER
| *a | Slide |
Slide the plate cover upward and remove it from the garnish.
9.REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
| *a | Rotate 90° |
Remove the bolt.
Rotate the adjuster approximately 90°, and then pull and remove the front shoulder belt anchor adjuster assembly.