Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.REMOVE NO. 1 SWITCH HOLE BASE
2.REMOVE CIGARETTE LIGHTER KNOB AND ELEMENT ASSEMBLY
3.REMOVE CIGARETTE LIGHTER COVER
| *A | w/ Illumination |
| *B | w/o Illumination |
Detach the 2 claws and remove the cigarette lighter cover.
4.REMOVE CIGAR LIGHTER SOCKET AND RETAINER ASSEMBLY
| *A | w/ Illumination |
| *B | w/o Illumination |
| *1 | Protective Tape |
Using a screwdriver, detach the claw, and remove the cigar lighter socket and retainer assembly.
Tape the screwdriver tip before use.
5.REMOVE CIGARETTE LIGHTER BEZEL STAY (w/ Illumination)
Detach the 2 claws and remove the cigarette lighter bezel stay.
6.REMOVE CIGARETTE LIGHTER INDICATOR LENS (w/o Illumination)
Detach the 2 claws and remove the cigarette lighter indicator lens.