Use the same procedure for the LH side and RH side.
The procedure listed below is for the LH side.
1.INSTALL FRONT SIDE FIX WINDOW ASSEMBLY LH
| *1 | Primer M |
| *2 | Adhesive |
| *a | CORRECT |
| *b | INCORRECT |
Using a brush or sponge, apply Primer M to the exposed part of the vehicle body.
Allow the primer to dry for 3 minutes or more.
Do not apply primer to the adhesive.
Throw away any leftover primer.
Do not apply too much primer.
Using a brush or sponge, apply Primer G to the contact surface of a new front side fix window.
| *1 | Primer G | - | - |
| *a | Backside | - | - |
| Area | Specified Condition |
|---|---|
| a | 8.0 mm (0.315 in.) |
| b | 16.0 mm (0.630 in.) |
If primer is applied to an area that is not specified, wipe off the primer with non-residue solvent before it dries.
Allow the primer to dry for 3 minutes or more.
Throw away any leftover primer.
Do not apply too much primer.
Apply adhesive to the front side fix window.
Toyota Genuine Windshield Glass Adhesive or Equivalent
Cut off a tip of the cartridge nozzle as shown in the illustration.
| *1 | Adhesive | - | - |
| *a | Backside | *b | Adhesive Center Line |
| Area | Specified Condition |
|---|---|
| a | 12.0 mm (0.472 in.) |
| b | 8.0 mm (0.315 in.) |
| c | 1.0 mm (0.0394 in.) |
After cutting off the tip, use all adhesive within the time written in the table below.
| Temperature | Usage Time Frame |
|---|---|
| 35°C (95°F) | 15 minutes |
| 20°C (68°F) | 1 hour 40 minutes |
| 5°C (41°F) | 8 hours |
Load a sealer gun with the cartridge.
Apply adhesive to the front side fix window as shown in the illustration.
Install the front side fix window to the vehicle body.
Lightly press the outer surface of the glass to ensure a close fit.
Using a scraper, remove any excess or protruding adhesive.
Apply adhesive to any areas where the amount of adhesive is inadequate.
Do not drive the vehicle for the amount of time written in the table below.
| Temperature | Minimum Time Prior to Driving Vehicle |
|---|---|
| 35°C (95°F) | 1 hour 30 minutes |
| 20°C (68°F) | 5 hours |
| 5°C (41°F) | 24 hours |
Hold the front side fix window in place securely with protective tape or equivalent until the adhesive hardens.
Allow the primer coating to dry for 3 minutes or more.
Check that the clips are attached to the body correctly.
Check that the vehicle body and fix window have a small gap between them.
2.CHECK FOR LEAKS AND REPAIR
Conduct a leak test after the adhesive has completely hardened.
Seal any leaks with auto glass sealer.
3.INSTALL FRONT PILLAR GARNISH LH
4.INSTALL LOWER FRONT PILLAR GARNISH LH