Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER
RM1880E _59 Vehicle Exterior _013254 EXTERIOR PANELS / TRIM _0068751 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).


PROCEDURE

Hide 1.INSTALL FRONT BUMPER NO. 2 RETAINER BRACKET

a.

Install the front bumper No. 2 retainer bracket with the bolt.


Hide 2.INSTALL FRONT BUMPER NO. 1 RETAINER BRACKET

HINT:

Use the same procedure described for the front bumper No. 2 retainer bracket.


Hide 3.INSTALL FRONT BUMPER SIDE SUPPORT LH

a.

Attach the 3 claws to install the front bumper side support.


b.

Install the 2 screws.


Hide 4.INSTALL FRONT BUMPER SIDE SUPPORT RH

HINT:

Use the same procedure described for the LH side.


Hide 5.INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY

a.

Install the front bumper reinforcement with the 4 nuts.

Torque:
67 N*m (683 kgf*cm, 49 ft.*lbf)


Hide 6.INSTALL RADIATOR SIDE DEFLECTOR LH

a.

Install the radiator side deflector with the 2 clips and bolt.


Hide 7.INSTALL RADIATOR SIDE DEFLECTOR RH

HINT:

Use the same procedure described for the LH side.


Hide 8.INSTALL FRONT BUMPER COVER

a.

w/ Fog Light:

Connect the 2 fog light connectors.


b.

Attach the 8 claws and 2 guides to install the front bumper cover.


c.

Install the 5 clips and 2 bolts.


d.

Install the 2 pin hold clips and 2 screws.


e.

Install the clip and 6 screws.


Hide 10.ADJUST FOG LIGHT AIMING (w/ Fog Light)