Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. REPAIR INSTRUCTION
2.INSTALL CENTER PILLAR BLACK OUT TAPE LH
When installing the center pillar black out tape, heat the vehicle body and center pillar black out tape using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Center Pillar Black Out Tape | 20 to 30°C (68 to 86°F) |
Do not heat the vehicle body or center pillar black out tape excessively.
Remove the release paper and apply the center pillar black out tape.
Press the center pillar black out tape firmly to install it.