Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type)
RM1880E _56 Audio / Visual / Telematics _013234 AUDIO / VIDEO _0068594 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) Y

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use these procedures to troubleshoot the audio and visual system.

·

For vehicles equipped with an Extension Module, check the following contents for the radio and display receiver assembly and the Extension Module. (Refer to optional equipment's manuals)



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
a.

Measure the battery voltage with the ignition switch off.

Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.



Result:
Proceed to
NEXT



NEXT

3.BASIC INSPECTION
3.BASIC INSPECTION
a.

Turn the ignition switch to ON.


b.

Check whether or not the display appears on the display and audio and visual module display.

Result:
Result Proceed to
Display appears A
Display does not appear B




A

4.CHECK FOR DTC

B

6.OVERALL ANALYSIS AND TROUBLESHOOTING
4.CHECK FOR DTC

b.

Clear the DTCs.


c.

Recheck for DTCs by simulating the operation indicated by the DTCs.

Result:
Result Proceed to
DTC is not output A
DTC is output B




A

5.PROBLEM SYMPTOMS TABLE

B

5.PROBLEM SYMPTOMS TABLE
a.

Refer to Problem Symptoms Table.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio and Display Type)>PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in problem symptoms table A
Fault is listed in problem symptoms table B



HINT:

If the symptom does not recur and no DTC is output, perform the symptom simulation method.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING



A

6.OVERALL ANALYSIS AND TROUBLESHOOTING

B

7.ADJUST, REPAIR OR REPLACE
6.OVERALL ANALYSIS AND TROUBLESHOOTING

NEXT

7.ADJUST, REPAIR OR REPLACE
7.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

8.CHECK FOR DIAGNOSTIC TROUBLE CODE
8.CHECK FOR DIAGNOSTIC TROUBLE CODE
HINT:

After clearing DTCs, recheck for DTCs.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio and Display Type)>DTC CHECK / CLEAR


Result:
Proceed to
NEXT



NEXT

9.PERFORM CONFIRMATION TEST
9.PERFORM CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END