1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from battery terminal notice before proceeding with work. (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION)
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
3.REMOVE FRONT FENDER SEAL
Remove the 5 clips and seal.
4.REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY (for Automatic Transmission)
5.DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)
6.REMOVE STARTER ASSEMBLY
Disconnect the starter connector.
Disconnect the terminal cap.
Remove the nut and disconnect the starter wire.
for Automatic Transmission:
Remove the 2 bolts and starter.
for Manual Transmission:
Remove the bolt and disconnect the clutch flexible hose bracket.
Remove the bolt and starter.