Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.REMOVE FRONT SEAT ASSEMBLY
2.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
Detach the clamp.
Detach the wire harness from the clamp.
Roll up over the front seat cushion cover LH.
Remove the nut and front seat inner belt assembly LH.
Remove the front seat belt anchor plate.
3.REMOVE FRONT SEAT INNER BELT ASSEMBLY RH
w/ Front Passenger Seat Belt Warning System:
Remove the hog rings and disconnect the cover from the front seat cushion frame sub-assembly RH.
| *a | Front |
Disconnect the connector.
Detach the 2 clamps.
Detach the wire harness from the clamp.
Roll up over the front seat cushion cover RH.
Remove the nut and front seat inner belt assembly RH.
Remove the front seat belt anchor plate.
w/o Front Passenger Seat Belt Warning System:
Roll up over the front seat cushion cover RH.
Remove the nut and front seat inner belt assembly RH.
Remove the front seat belt anchor plate.
4.REMOVE FRONT SEAT CUSHION COVER LH
Remove the front seat cushion cover LH from the front seat inner belt assembly LH.
Use the same procedure described for the RH side.