Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER RH
Using hog ring pliers, install the separate type front seat cushion cover RH to the separate type front seat cushion pad RH with new hog rings.
| *A | for Vinyl Seat, for Cloth Seat | *B | for Leather Seat |
| *1 | Hog Ring Pliers | - | - |
Be careful not to damage the cover.
When installing the hog rings, avoid wrinkling the cover.
Attach the hooks to install the separate type front seat cushion cover RH with pad to the front seat cushion frame sub-assembly RH.
Bend the 2 front seat cushion frame claws downward.
| *1 | Hog Ring Pliers |
Using hog ring pliers, install the separate type front seat cushion cover RH to the front cushion frame sub-assembly RH with new hog rings.
Attach the wire harness clamp.
2.INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY RH
Install the separate type front seatback assembly RH with the 4 bolts.
3.INSTALL SEATBACK SPRING RH
Install the seatback spring RH.
4.INSTALL FRONT SEAT CUSHION SHIELD RH
| *1 | Guide |
| *2 | Hook |
Attach the guide, and then attach the 2 hooks in the order shown in the illustration to install the front seat cushion shield RH.
Install the 2 screws.
5.INSTALL RECLINING ADJUSTER RELEASE HANDLE RH
Attach the claw to install the reclining adjuster release handle RH.
6.INSTALL FRONT SEAT INNER CUSHION SHIELD RH
Attach the 2 hooks in the order shown in the illustration to install the front seat cushion shield RH.
Install the 2 screws.
7.INSTALL FRONT SEAT CUSHION COVER RH
Install the front seat cushion cover RH.
8.INSTALL FRONT SEAT INNER BELT ASSEMBLY RH
9.INSTALL FRONT SEAT ASSEMBLY RH