2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Clearance Warning ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This circuit provides power to operate the clearance warning ECU.

WIRING DIAGRAM

E283774E02

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - BATTERY)

  1. B155759E16
    Disconnect the clearance warning ECU connector.

  1. Measure the voltage according to the value(s) on the table below.

    Standard Voltage:
    for 4 Sensor Type 
    Tester Connection
    Switch Condition
    Specified Condition
    I1-15 (IG) - Body ground
    Engine switch on (IG)
    11 to 14 V
    I1-15 (IG) - Body ground
    Engine switch off
    Below 1 V
    for 8 Sensor Type 
    Tester Connection
    Switch Condition
    Specified Condition
    G154-15 (IG) - Body ground
    Engine switch on (IG)
    11 to 14 V
    G154-15 (IG) - Body ground
    Engine switch off
    Below 1 V

    Text in Illustration 
    *A
    for 4 Sensor Type
    *B
    for 8 Sensor Type
    *a
    Front view of wire harness connector
    (to Clearance Warning ECU)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - BODY GROUND)

  1. B155759E17
    Disconnect the clearance warning ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for 4 Sensor Type 
    Tester Connection
    Condition
    Specified Condition
    I1-17 (E) - Body ground
    Always
    Below 1 Ω
    for 8 Sensor Type 
    Tester Connection
    Condition
    Specified Condition
    G154-17 (E) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *A
    for 4 Sensor Type
    *B
    for 8 Sensor Type
    *a
    Front view of wire harness connector
    (to Clearance Warning ECU)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Clearance Warning ECU Power Source Circuit (Aug 2013 – Jul 2014)PRECAUTION (from Aug 2013) →