2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

PROBLEM SYMPTOMS TABLE

Troubleshooting · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.
  3. When open circuit indication is displayed during the self-check function, check for DTCs and troubleshoot according to each inspection procedure.

General 
Symptom
Suspected Area
See page
System does not operate at all (self-check function does not operate)
Proceed to "Clearance Warning ECU Power Source Circuit"
Click here
Replace clearance warning ECU (for LHD)
Click here
Replace clearance warning ECU (for RHD)
Click here
System cannot be turned off
Replace clearance warning ECU (for LHD)
Click here
Replace clearance warning ECU (for RHD)
Click here
Sonar Function 
Symptom
Suspected Area
See page
Frozen indication is displayed in self-check function
Refer to Precaution
Click here
Replace ultrasonic sensor in part where frozen indication is displayed
-
Replace clearance warning ECU (for LHD)
Click here
Replace clearance warning ECU (for RHD)
Click here
Combination meter assembly (shift indicator) operates normally, but detection operates when shift lever is in P, or detection does not operate when shift lever is in any position except P (front corner ultrasonic sensor) (for 8 Sensor Type)
Replace clearance warning ECU (for LHD)
Click here
Replace clearance warning ECU (for RHD)
Click here
Combination meter assembly (shift indicator) operates normally, but detection operates when shift lever is in P or R, or detection does not operate when shift lever is in any position except P and R (front center ultrasonic sensor) (for 8 Sensor Type)
Replace clearance warning ECU (for LHD)
Click here
Replace clearance warning ECU (for RHD)
Click here
Combination meter assembly (shift indicator) operates normally, but detection operates when shift lever is in any position except R, or does not operate with the shift lever in R (rear ultrasonic sensor)
Proceed to "Reverse Signal Circuit"
Click here
Replace clearance warning ECU (for LHD)
Click here
Replace clearance warning ECU (for RHD)
Click here
Detection operation operates even when vehicle speed exceeds operation condition speed
Replace clearance warning ECU (for LHD)
Click here
Replace clearance warning ECU (for RHD)
Click here
Buzzer Function 
Symptom
Suspected Area
See page
Sonar detection operation is normal but buzzer operation is intermittent
Proceed to "Clearance Warning Buzzer Circuit"
Click here
Replace clearance warning ECU (for LHD)
Click here
Replace clearance warning ECU (for RHD)
Click here
Display Function 
Symptom
Suspected Area
See page
Detection operation is normal but clearance sonar indicator does not illuminate
Combination meter assembly (Active Test)
Click here
Replace clearance warning ECU (for LHD)
Click here
Replace clearance warning ECU (for RHD)
Click here
Detection operation is normal but no sonar displays appear
Replace clearance warning ECU (for LHD)
Click here
Replace clearance warning ECU (for RHD)
Click here
Detection operation is normal but sonar displays of multi-information display do not appear
Replace combination meter assembly
Click here
Replace clearance warning ECU (for LHD)
Click here
Replace clearance warning ECU (for RHD)
Click here
Detection operation is normal but sonar displays of multi-display do not appear
Replace navigation receiver assembly (for Navigation Receiver Type)
Click here
Replace navigation receiver assembly (for Built-in Memory)
Click here
Replace radio and display receiver assembly (for Radio and Display Type)
Click here
Replace clearance warning ECU (for LHD)
Click here
Replace clearance warning ECU (for RHD)
Click here
Switch Function 
Symptom
Suspected Area
See page
Clearance sonar main switch does not operate
Proceed to "B2660" (for 8 Sensor Type)
Click here
Proceed to "Main Switch Circuit"
Click here
Replace clearance warning ECU (for LHD)
Click here
Replace clearance warning ECU (for RHD)
Click here
← PROBLEM SYMPTOMS TABLE (Aug 2013 – Jul 2014)TERMINALS OF ECU (from Aug 2013) →