2013-2015 Land Cruiser Prado · Service Manual Drivetrain

INSTALLATION

Removal / installation · Vehicles built from Aug 2013


1. INSTALL CLUTCH DISC ASSEMBLY

  1. C215507E01
    Insert SST into the clutch disc, and then install SST and the clutch disc together to the flywheel.
    SST
    09301-00110  
    Text in Illustration 
    V100135
    Flywheel Side

    NOTICE:
    Be sure to install the clutch disc so that it is facing in the correct direction.


2. INSTALL CLUTCH COVER ASSEMBLY

C215508E01
  1. Align the matchmark on the clutch cover with the one on the flywheel.

    Text in Illustration 
    *a
    Matchmark

  1. Following the order shown in the illustration, tighten the 6 bolts, starting with the bolt located near the knock pin at the top.

    SST
    09301-00110  

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }

    HINT:
    1. Following the order in the illustration, tighten the bolts evenly one at a time.
    2. Move SST up and down, and right and left lightly after checking that the clutch disc assembly is in the center, and then tighten the bolts.


3. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY

C215509E01
  1. Using a dial indicator with a roller instrument, check the diaphragm spring tip alignment.

    SST
    09333-00013  

    Maximum misalignment:
    1.3 mm (0.0512 in.)

    If the misalignment is more than the maximum, using SST, adjust the diaphragm spring tip alignment.


4. INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY

  1. C163041E03
    Apply release hub grease to the release fork, release bearing, push rod contact point and pivot points shown in the illustration.

    Grease:
    Toyota Genuine Release Hub Grease or equivalent

    Text in Illustration 
    *1
    Release hub grease

  1. C215510E01
    Apply clutch spline grease to the input shaft spline.

    Grease:
    Toyota Genuine Clutch Spline Grease or equivalent

    Text in Illustration 
    *1
    Clutch spline grease

  1. Install the clutch release bearing to the clutch release fork with the clip.

  1. Install the release fork support to the transmission unit.

    Torque:
    47 N*m{ 480 kgf*cm , 35 ft.*lbf }

  1. Install the clutch release fork with the clutch release bearing to the transmission unit.

    HINT:
    After installation, move the fork back and forth to check that the release bearing slides smoothly.


5. INSTALL MANUAL TRANSMISSION ASSEMBLY
  1. Install the manual transmission (Click here).

← INSPECTION (from Aug 2013)COMPONENTS (from Aug 2013) →