2013-2015 Land Cruiser Prado · Service Manual Drivetrain

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT CLUTCH DISC ASSEMBLY

NOTICE:
When replacing the clutch disc assembly, make sure to perform an inspection of the flywheel sub-assembly and clutch cover assembly.

  1. C173305
    Using a vernier caliper, measure the rivet depth.

    Minimum rivet depth:
    0.3 mm (0.0118 in.)

    If the depth is less than the minimum, replace the clutch disc assembly.

  1. CL00373E01
    Using a dial gauge, measure the clutch disc assembly runout.

    Maximum runout:
    0.7 mm (0.0276 in.)

    If the runout is more than the maximum, replace the clutch disc assembly.


INSPECT CLUTCH COVER ASSEMBLY

C173310E02
  1. Using a vernier caliper, measure the depth and width of the diaphragm spring wear.

    Maximum Wear:
    Depth
    Width
    0.35 mm (0.0138 in.)
    5.0 mm (0.197 in.)

    Text in Illustration 
    *a
    Width
    *b
    Depth
    If the depth or width is more than the maximum, replace the clutch cover assembly.

  1. A272260E01
    Perform a visual inspection of the clutch cover assembly.

    1. Inspect for hair cracks or scratches extending from the center outwards, or discoloration.

    2. Inspect for hair cracks in a circular pattern, discoloration or excessive wear.

      Text in Illustration 
      *1
      Hair cracks, scratches or discoloration
      *2
      Hair cracks, discoloration or excessive wear
      If there is any damage, replace the clutch cover assembly.


INSPECT FLYWHEEL SUB-ASSEMBLY

C215503
  1. Using a dial gauge, check the flywheel sub-assembly runout.

    Maximum runout:
    0.1 mm (0.00393 in.)

    If the runout is more than the maximum, replace the flywheel sub-assembly.

  1. A272261E01
    Perform a visual inspection of the flywheel sub-assembly.

    1. Inspect for hair cracks or scratches extending from the center outwards, or discoloration.

    2. Inspect for hair cracks in a circular pattern, discoloration or excessive wear.

      Text in Illustration 
      *1
      Hair cracks, scratches or discoloration
      *2
      Hair cracks, discoloration or excessive wear
      If there is any damage, replace the flywheel sub-assembly.


INSPECT CLUTCH RELEASE BEARING ASSEMBLY

F050790E01
  1. Check that the clutch release bearing moves smoothly without abnormal resistance by turning the sliding parts of the clutch release bearing (contact surfaces with the clutch cover) while applying force in the axial direction.

  1. Inspect the clutch release bearing for damage or wear.
    If necessary, replace the release bearing assembly.

← REMOVAL (from Aug 2013)INSTALLATION (from Aug 2013) →