Disc cannot be Inserted or is Ejected Right After Insertion
Circuit diagnosis · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
INSPECTION PROCEDURE
- HINT:
- When replacing the radio and display receiver assembly, it is necessary to perform the vehicle contract setting for Connected Services (w/ Connected Services Function).
| 1. CHECK IF A PROPER DISC IS INSERTED |
Make sure that the CD is an audio disc or a disc with MP3, WMA or ACC files, and that it is not deformed, flawed, stained, deteriorated or otherwise defective.
- OK:
- Disc is normal.
- HINT:
- Translucent or uniquely-shaped CDs cannot be played.
- CDs and DVDs with adhesive paper labels should not be played.
- Commercial audio CDs and DVDs can be played.
- CD-DA files on CD-ROMs, CD-Rs and CD-RWs can be played.
- MP3, WMA and AAC files on CD-ROMs, CD-Rs and CD-RWs can be played.
- For details on playable CDs and DVDs, refer to the Owner's Manual.
- Translucent or uniquely-shaped CDs cannot be played.
|
|
||||
| OK | |
| 2. CHECK THAT DISC IS INSERTED PROPERLY |
Check whether or not the disc is inserted upside down.
- OK:
- The disc is properly inserted.
|
|
||||
| OK | |
| 3. CLEAN DISC AND RECHECK |
Clean the disc by wiping it clean with a soft cloth from the inside to the outside in a radial direction.

- OK:
- Malfunction disappears.
- NOTICE:
- Do not use a conventional record cleaner or anti-static preservative.
|
|
||||
| OK | ||
| ||
| 4. REPLACE DISC AND RECHECK |
Replace the disc with a known good one and check that the malfunction disappears.
- OK:
- The malfunction disappears.
|
|
||||
| OK | ||
| ||
