2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

PRECAUTION

Precautions · Vehicles built from Aug 2013


1.IGNITION SWITCH EXPRESSION
  1. The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

    Expression
    Ignition Switch (Position)
    Engine Switch (Condition)
    Ignition Switch off
    LOCK
    Off (Lock)
    Ignition Switch ACC
    ACC
    On (ACC)
    Ignition Switch ON
    ON
    On (IG)
    Engine Start
    START
    Start


2.INITIALIZATION

NOTICE:
  1. Perform initialization (throttle position) after replacing the throttle body with motor assembly or cleaning any throttle body components (Click here).
  2. Perform initialization (throttle position) after reconnecting the battery cable or replacing the ECM (Click here).
  3. Perform reset memory (A/T initialization) when replacing the automatic transmission assembly, engine assembly or ECM (Click here).
  4. If the ECM is replaced, register the ECM communication ID for the immobiliser system (refer to the Service Bulletin for Registration).

HINT:
Initialization cannot be completed only by disconnecting the cable from the battery terminal.


3.USING INTELLIGENT TESTER

CAUTION:
Observe the following items for safety reasons:

  1. Read the tester's instruction books before using the tester.
  2. Make sure that the tester cable is not caught on the pedals, shift lever or steering wheel when driving with the tester connected to the vehicle.
  3. When driving the vehicle for testing purposes using the tester, two persons are required. One person drives the vehicle and the other operates the tester.

4.DISCONNECT AND RECONNECT CABLE OF NEGATIVE BATTERY TERMINAL
D033496E05
  1. Before performing electronic work, disconnect the cable from the negative (-) battery terminal in order to prevent it from shorting and burning out.

     
    *1
    Cable
    *2
    Negative (-) Battery Terminal

  2. Before disconnecting and reconnecting the battery cable, turn the ignition switch off and the headlight dimmer switch off. Then loosen the terminal nut completely. Do not damage the cable or terminal.

  3. When the battery cable is disconnected, the clock and radio settings and stored DTCs are cleared. Therefore, before disconnecting the battery cable, make a note of the settings.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

← GENERAL MAINTENANCE (from Aug 2013)PARTS LOCATION (from Aug 2013) →