2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
*: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
      NEXT

      3.CONNECT INTELLIGENT TESTER TO DLC3*

        HINT:
        If the display indicates a communication fault in the tester, inspect the DLC3.
        When any CAN communication system DTCs are output, perform troubleshooting for the CAN communication system first.

      NEXT

      4.CHECK DTC AND FREEZE FRAME DATA*

        HINT:
        If necessary, record or print DTCs and freeze frame data.
        1. Check for DTCs (Click here).
        1. Check the freeze frame data (Click here).

      NEXT

      5.CLEAR DTC AND FREEZE FRAME DATA*

        HINT:
        Refer to the relevant section (Click here).

      NEXT

      6.CONDUCT VISUAL INSPECTION
        NEXT

        7.SET CHECK MODE DIAGNOSIS*

          HINT:
          Refer to Check Mode Procedure (Click here).

        NEXT

        8.CONFIRM PROBLEM SYMPTOMS

          HINT:
          1. Refer to Problem Symptoms Table (Click here).
          2. If the engine does not start, first perform the Check for DTC procedure and Conduct Basic Inspection procedure below.
            Result 
            Result
            Proceed to
            Malfunction does not occur
            A
            Malfunction occurs
            B


        B.
        A

        9.SIMULATE SYMPTOMS
          NEXT

          10.CHECK FOR DTC*

            HINT:
            Refer to the relevant section (Click here).

            Result 
            Result
            Proceed to
            Trouble code output
            A
            No trouble code output
            B

          B.
          A

          11.REFER TO DTC CHART

            HINT:
            Refer to the relevant section (Click here).

          NEXT

          12.CONDUCT BASIC INSPECTION
            Result 
            Result
            Proceed to
            Malfunctioning parts not confirmed
            A
            Malfunctioning parts confirmed
            B

          B.
          A

          13.REFER TO PROBLEM SYMPTOMS TABLE

            HINT:
            Refer to Problem Symptoms Table (Click here).

            Result 
            Result
            Proceed to
            Malfunctioning circuit confirmed
            A
            Malfunctioning parts confirmed
            B

          B.
          A

          14.CHECK ECM POWER SOURCE CIRCUIT

            HINT:
            Refer to the relevant section (Click here).

          NEXT

          15.CONDUCT CIRCUIT INSPECTION
            Result 
            Result
            Proceed to
            Malfunction not confirmed
            A
            Malfunction confirmed
            B

          B.
          A

          16.CHECK FOR INTERMITTENT PROBLEMS
            NEXT

            17.CONDUCT PARTS INSPECTION
              NEXT

              18.IDENTIFY PROBLEM
                NEXT

                19.ADJUST AND/OR REPAIR
                  NEXT

                  20.CONDUCT CONFIRMATION TEST
                    NEXT

                    ← SYSTEM DIAGRAM (from Aug 2013)HOW TO PROCEED WITH TROUBLESHOOTING (from Aug 2014) →