2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

BASIC INSPECTION

Troubleshooting · Vehicles built from Aug 2013

When a malfunction cannot be confirmed by the DTC check, troubleshooting should be carried out for all circuits considered to be possible causes of the problem. In many cases, by performing the basic engine check shown in the following flowchart, the location of the problem can be found quickly and efficiently. Therefore, using this check is essential when troubleshooting the engine.

1.CHECK BATTERY VOLTAGE

    NOTICE:
    Perform this check with the engine stopped and the ignition switch off.

    Result 
    Result
    Proceed to
    11 V or higher
    OK
    Below 11 V
    NG

NG.
OK

2.CHECK WHETHER ENGINE CRANKS

    NG.
    OK

    3.CHECK WHETHER ENGINE STARTS

      NG.
      OK

      4.CHECK AIR FILTER
      1. Visually check that the air filter is not excessively contaminated with dirt or oil.


      NG.
      OK

      5.CHECK IDLING SPEED

        NG.
        OK

        6.CHECK FUEL PRESSURE

          NG.
          OK

          7.CHECK FOR SPARK

            NG.
            OK

            ← CHECK FOR INTERMITTENT PROBLEMS (from Aug 2013)PROBLEM SYMPTOMS TABLE (Aug 2013 – Jul 2014) →