TERMINALS OF ECU
System information · Vehicles built from Aug 2013
| CHECK HEADLIGHT SWIVEL ECU ASSEMBLY (w/ Automatic Headlight Beam Level Control System) |


Disconnect the A58 headlight swivel ECU connector.
Measure the resistance and voltage according to the value(s) in the table below.
If the result is not as specified, there may be a malfunction on the wire harness side.Terminal No. (Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
A58-22 (E1) - Body ground
W-B - Body ground
Headlight swivel ECU ground
Always
Below 1 Ω
A58-15 (IG) - Body ground
G - Body ground
Headlight swivel ECU power supply
Ignition switch off
Below 1 V
Ignition switch ON
11 to 14 V
Reconnect the A58 headlight swivel ECU connector.
Measure the resistance and voltage according to the value(s) in the table below.
Terminal No. (Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
A58-21 (SGF) - A58-22 (E1)
W - W-B
Rear height control sensor ground
Always
Below 1 Ω
A58-27 (LH-) - A58-22 (E1)
LG - W-B
Leveling motor LH ground
Always
Below 1 Ω
A58-28 (RH-) - A58-22 (E1)
LG - W-B
Leveling motor RH ground
Always
Below 1 Ω
A58-3 (LHT) - A58-22 (E1)
L - W-B
Leveling motor LH power supply
Ignition switch off
Below 1 V
Ignition switch ON
11 to 16 V
A58-4 (RHT) - A58-22 (E1)
GR - W-B
Leveling motor RH power supply
Ignition switch off
Below 1 V
Ignition switch ON
11 to 16 V
A58-7 (INIT) - A58-22 (E1)
R - W-B
Initialization signal
Ignition switch ON, terminals LVL and GND of DLC3 connected
Below 1 V
Ignition switch ON, terminals LVL and GND of DLC3 not connected
Approximately 5 V
A58-11 (RH+) - A58-22 (E1)
R - W-B
Leveling motor RH LIN communication
Ignition switch off
Below 1 V
Ignition switch ON
Pulse generation
A58-18 (SBF) - A58-21 (SGF)
R-G - W
Rear height control sensor power supply
Ignition switch off
Below 1 V
Ignition switch ON
Approximately 5 V
A58-19 (SHRL) - A58-21 (SGF)
B-R - W
Rear height control sensor signal
Ignition switch off
Below 1 V
Ignition switch ON
1 to 4 V
A58-30 (LH+) - A58-22 (E1)
R - W-B
Leveling motor LH LIN communication
Ignition switch off
Below 1 V
Ignition switch ON
Pulse generation
| CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY, MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |


| *A |
for LHD |
*B |
for RHD |
| *1 |
Main Body ECU (Multiplex Network Body ECU) |
- |
- |
Remove the main body ECU (Click here).
Measure the resistance and voltage according to the value(s) in the table below.
If the result is not as specified, there may be a malfunction on the wire harness side.Terminal No. (Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
A-29 (ACC) - Body ground
-
ACC power supply
Ignition switch ACC
11 to 14 V
Ignition switch off
Below 1 V
A-30 (BECU) - Body ground
-
Battery power supply
Always
11 to 14 V
A-32 (IG) - Body ground
-
Ignition power supply
Ignition switch ON
11 to 14 V
Ignition switch off
Below 1 V
A-11 (GND1) - Body ground
-
Ground
Always
Below 1 Ω
G63-3 (GND2) - Body ground
W-B - Body ground
Ground
Always
Below 1 Ω
Install the main body ECU (Click here).
Measure the voltage according to the value(s) in the table below.
Terminal No. (Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
G63-23 (RFOG) - 2D-4 (GND1)*5
SB - W-B
Rear fog light switch input
Rear fog light switch on
Below 1 V
Rear fog light switch off
11 to 14 V
G64-1 (GCTY) - 2D-4 (GND1)*6
V - W-B
Glass hatch courtesy light switch signal
Glass hatch open
Below 1 V
Glass hatch closed
11 to 14 V
G64-3 (HAZ) - 2D-4 (GND1)
W - W-B
Hazard warning signal switch output
Hazard warning signal switch on
11 to 14 V
Hazard warning signal switch off
Below 1 V
G64-5 (HU) - 2D-4 (GND1)
LG - W-B
Headlight dimmer switch high signal input
Headlight dimmer switch in high
Below 1 V
Headlight dimmer switch in low
11 to 14 V
G64-6 (RCTY) - 2D-4 (GND1)*7
R - W-B
Rear door courtesy light switch RH signal
Rear door RH open
Below 1 V
Rear door RH closed
11 to 14 V
G64-8 (HF) - 2D-4 (GND1)
V - W-B
Headlight dimmer switch high flash signal input
Headlight dimmer switch in high flash position
Below 1 V
Headlight dimmer switch not in high flash position
11 to 14 V
G64-15 (DIM) - 2D-4 (GND1)
P - W-B
H-LP HI relay drive output
Headlight dimmer switch in high or high flash
Below 1 V
Headlight dimmer switch not in high or high flash
11 to 14 V
G64-19 (BCTY) - 2D-4 (GND1)
G - W-B
Back door courtesy light switch signal
Back door open
Below 1 V
Back door closed
11 to 14 V
G64-20 (CLTB) - 2D-4 (GND1)*3
P - W-B
Automatic light control sensor power supply output
Ignition switch off
Below 1 V
Ignition switch ON and headlight dimmer switch in AUTO position
11 to 14 V
G64-21 (CLTS) - 2D-4 (GND1)*3
R - W-B
Automatic light control sensor signal input
Ignition switch off
Below 1 V
Ignition switch ON
Headlight dimmer switch AUTO
Automatic light control sensor covered with a hand → Automatic light control sensor exposed to ambient light
Pulse generation
(See waveform 1)
G64-27 (FFOG) - 2D-4 (GND1)*4
G - W-B
Front fog light switch input
Front fog light switch on
Below 1 V
Front fog light switch off
11 to 14 V
G64-28 (A) - 2D-4 (GND1)*3
W - W-B
Headlight dimmer switch AUTO signal input
Headlight dimmer switch in AUTO
Below 1 V
Headlight dimmer switch not in AUTO
11 to 14 V
G64-29 (HEAD) - 2D-4 (GND1)
SB - W-B
Headlight dimmer switch head signal input
Headlight dimmer switch in head
Below 1 V
Headlight dimmer switch not in head
11 to 14 V
G64-30 (TAIL) - 2D-4 (GND1)
W - W-B
Headlight dimmer switch tail signal input
Headlight dimmer switch in tail or head
Below 1 V
Headlight dimmer switch in neither tail nor head
11 to 14 V
G65-3 (LCTY) - 2D-4 (GND1)*7
V - W-B
Rear door courtesy light switch LH signal
Rear door LH open
Below 1 V
Rear door LH closed
11 to 14 V
2D-15 (FRCY) - 2D-4 (GND1)*1
2H-26 (FRCY) - 2D-4 (GND1)*2
B - W-B
Front door courtesy light switch RH signal
Front door RH open
Below 1 V
Front door RH closed
11 to 14 V
2F-7 (TRLY) - 2D-4 (GND1)
LG - W-B
Clearance light signal output
Headlight dimmer switch in tail position
11 to 14 V
Headlight dimmer switch not in tail position
Below 1 V
2F-9 (FFGO) - 2D-4 (GND1)*4
W - W-B
Front fog light signal output
Headlight dimmer switch in tail and front fog light switch on
Below 1 V
Front fog light switch off
11 to 14 V
2F-19 (RFGO) - 2D-4 (GND1)*5
GR-L - W-B
Rear fog light signal output
Headlight dimmer switch in tail and rear fog light switch on
Below 1 V
Rear fog light switch off
11 to 14 V
2F-24 (PANL) - 2D-4 (GND1)*8
P - W-B
DRL relay drive output
Daytime running light off
Below 1 V
Daytime running light on
11 to 14 V
2F-40 (HRLY) - 2D-4 (GND1)
GR - W-B
H-LP LO relay drive output
Headlight dimmer switch in head
Below 1 V
Headlight dimmer switch not in head
11 to 14 V
2I-16 (TRLY) - 2D-4 (GND1)*1
2D-32 (TRLY) - 2D-4 (GND1)*2
LG - W-B
Taillight and license plate light signal output
Headlight dimmer switch in tail position
11 to 14 V
Headlight dimmer switch not in tail position
Below 1 V
2I-27 (FLCY) - 2D-4 (GND1)*1
2D-31 (FLCY) - 2D-4 (GND1)*2
R - W-B
Front door courtesy light switch LH signal
Front door LH open
Below 1 V
Front door LH closed
11 to 14 V
2K-1 (TRLY) - 2D-4 (GND1)
B - W-B
Battery power supply
Always
11 to 14 V
- *1: for LHD
- *2: for RHD
- *3: w/ Automatic Light Control System
- *4: w/ Front Fog Light
- *5: w/ Rear Fog Light
- *6: w/ Glass Hatch Opener System
- *7: for 5 Door
- *8: w/ Daytime Running Light
Waveform 1

Item
Content
Terminal No. (Symbol)
G64-21 (CLTS) - 2D-4 (GND1)
Tool setting
5 V/DIV., 5 ms./DIV.
Condition
Ignition switch ON
Headlight dimmer switch AUTO
Automatic light control sensor covered with a hand → Automatic light control sensor exposed to ambient light
- HINT:
- When the ambient light becomes brighter, width A becomes narrower.
- *1: for LHD